This image represents a sample approximately 600mm wide. The appearance of the veneer laminate on your screen, on a sample and on that used in a project may differ from each other. This is because wood veneer is a natural product and may vary in appearance from log to log, within a log and from leaf to leaf/across a sheet. This product may have natural features such as pin knots, gum, figure, slanted or curved direction of grain, different leaf widths, off-centred crowns etc. It may have manufacturing features such as join lines, brush marks, knife-rub-marks, slight indentations and some variation in the appearance of how stains/washes/tints are taken up by different leaves or logs. These are not defects but due to the intrinsic properties of natural wood veneer, its processing and coating/finishing.

Oberflex Spice Nutmeg


Oberflex Spice Nutmeg

About this Product: Made in France from real wood veneer bonded under ultra-high pressure to a laminate backing, with the veneer being impregnated and surfaced with a very hard cured melamine resin. Coloured stains and patterns are pre-applied to some Oberflex to create tints not achievable in ordinary veneer. Oberflex retains the appearance of real timber veneer, whilst also having very high wear, scratch, stain, impact and moisture resistance. Ideal for interior vertical and horizontal applications where high wear, scratch and stain-resistance is required such as restaurant table tops, reception counter tops and fronts, vanity doors and kitchen doors. Supplied finished (at thicknesses from 1mm to 1.2mm), Oberflex® has reduced fabrication time. The appearance of this veneer laminate may vary because wood is a natural product and also becuase there may be and some variation in the appearance of how stains are taken up by different leaves or logs. Cannot be post-formed, but can be cold bent to a radius of 500mm.
Laminate sheet size(s): 3050mmx1250mm
Typical Finished Panel size(s): 3000mmx1200mm
Thickness of laminate: 1.1mm
Product Data Sheet: Download
Availability: Good availability
Price zone: Above average
Applications: Especially suited where ultra-high wear and stain resistance is required, whilst maintaining the presence of high quality real natural wood veneer, such as shop-fitting applications, office work stations, dry horizontal applications such as ceiling panels, counter-tops, desk- and table-tops. It should not be used for floors, stair treads, kitchen counter-tops, high humidity/wet/steamy/damp conditions, exterior applications, areas exposed to temperatures above 60 degrees C or areas around stoves and fireplaces. Note that the appearance of veneer may change over time due to direct and indirect light, and exposure to heat. Some sheets of veneer laminate may age differently to others. Keep out of direct sunlight. Note that wire-brushed laminates may be hard to clean. As it is not possible to cover all associated manufacturing materials, conditions, products and methods, the end-user is responsible for carrying out the necessary tests and trials to check that this product, fabrication methods, associated materials and cleaning products/methods are suitable.
About & Applications information: Download
Colour/Appearance: Striped/Multi-coloured
Consistency of Appearance: Better than average
Made from: Resin impregnated wood veneer, with a striped & stained surface - finished with a hard melamine surface and bonded onto a laminate backer
Origin: European Union
Handling and Care instructions Download
Edging availability: Self-edge with same laminate. The side of the edge-strips must be sealed with a lacquer pen or similar.
Finish: Prefinished - Matt. Brushed texture
Pressing, Finishing & Fabrication information Download
Environmental: Sustainably managed
Environment Health & Safety information Download
Available as environmentally certified: No
Emissions from laminate: Formaldehyde - Less than 0.13 mg/m3 Formaldehyde = E1
Formaldehyde certificate Download
VOC emissions certificate: Download
Material Safety Data Sheet Download
Fire Hazard Group 1 and Group 2 not possible at this stage
Fire Hazard Group 3 Report - tests and Assessment in progress